-
Recent Posts
-
February 2012 M T W T F S S « Apr 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 Archives
Tag Archives: ping
Juniper Routers Tutorial
Juniper Networks Router Design The central design principle of the Juniper Networks platform centers on a separation of the control and forwarding planes within the router. The Routing Engine and the Packet Forwarding Engine, respectively, represent these planes. Routing Engine Overview The Routing Engine in a Juniper Networks router is the central location for control of the system responsible for: • Storing the JUNOS software & Performing software upgrades • Monitoring and configuring the router. • … More ->
Tagged Altering the Configuration, BGP STATE & RECEIVED PREFIXES STATS, Command Completion, Command-Line Interface, Commit Command, Configuration Mode, Configure the Backbone Area, Context-Sensitive Help, Disabling/Deactivating Interface, Flexible PIC Concentrator, Getting Help from the Router, Juniper Networks Router Design, Juniper Routers Introduction, Juniper Routers Tutorial, JUNOS software CLI, JUNOS Software Routing Table, Monitoring and configuring the router, Operational Mode, or traceroute, Packet Forwarding Engine, Permanent Interfaces, Physical Interface Card, ping, Protocol Addresses, Protocol MTU, Restoring an Old Configuration, Run Command, toring the JUNOS software, Transient Interfaces, Troubleshooting tools like Telnet, Using the Pipe through a command
1 Comment